"Chart trader" in NT, limitations. Fix?

[NinjaTrader_Matthew]

Were the stop orders submitted under the same price initially? From the Orders tab, are there two separate working orders, or is there a single order set to a qty of 2?

[pmaglio]

ju1234 ; you can still divide all orders from chart trader ( or DOM ) by just selecting "DisplaySelectedATMStrategyOnly" on Selection Mode...
...check my previous post..

Regards,
Pablo

[ju1234]

Were the stop orders submitted under the same price initially? From the Orders tab, are there two separate working orders, or is there a single order set to a qty of 2?

Two separate orders under two instances of ATM. I can separate the limit T1 orders from Orders console but not stops.

[ju1234]

PMaglio: Thank you very much. You appear to have good command on this software. I assume you are a successful and profitable trader.

Do you mind sharing your trading techniques.

[pmaglio]

PMaglio: Thank you very much. You appear to have good command on this software. I assume you are a successful and profitable trader.

Do you mind sharing your trading techniques.

Thanks ju1234
take a look at this video to see an easy way to split orders from chart trader :

http://screencast.com/t/Ja1ue8PuWa

btw, I share all my techniques on my blog :

http://theindicatorstore.blogspot.com.ar/

Regards,
Pablo Maglio
The Indicator Store

[ju1234]

Continuing issues

Kind of continuing problems in this area: Here is what happened:

Using ATM ES1/8/8 I placed a "limit sell" order at 1501. Before this is filled, in the chart trader panel I started another instance of ES1/8/8 and place an order to "limit buy" at 1500. The Buy order filled and created T1 at 1502 and Stop at 1498. Because limit sell at 1501 is below T1 at 1502, limit sell at 1501 was triggered. Of course the Limit sell is a 2nd instance, so another set of T1 and S1 was created. Now I have 2 T1s and 2 S1s but no positions. If T1 is filled the associated S1 is going to be automatically be canceled and vice versa leaving me net long or short when it is not intended. Is there a way around so this does not happen?

[pmaglio]

Hi,

This is normal, you are flat for the borker, but have a long with its targets and stops and short with its own targets and stops....there is no issue....
Again, you can split both orders and look at your individual long and short positions by using "DisplaySelectedATMStrategyOnly" on Selection Mode...
Best Regards,
Pablo / The Indicator Store