I have a lot of parameters in my Strategies, and when I use the optimiser the only way I can pick out of, say, 30+ parameters which one is being optimised and what its value is is by painstakingly eyeballing through the long list of parameters in Excel (because the only way a long list of parameters can be seen in Ninja is a mouse-over float which doesn't stay more than a few seconds.)
Please could there be a display about the parameters which were being optimised and their value which produced the result I'm looking at.
The way it is set up at the moment is fine if there are only a handful of parameters in a Strategy. It can be seen ok in the window. But truly, I have 50 parameters in the strategy I am currently optimising and it is a nightmare.
Note that this could be done in the Settings Tab, which ironically is where you would expect to find this information but instead all it shows is the RANGE of values it was optimising, NOT the specific value for this result.
Hoping with crossed fingers.
saltminer
Comment