Limiting Trades in Ninjascript Strategy using ATM Strategy to 1

[TradingLoss]

Given EntriesPerDirection don't apply when using AtmStrategyCreate(), is there a way I can limit trades to 1 strategy execution until the current strategy hits its target or stop, at the current moment, the strategy keeps taking all conditions with "open[0] > close[1]", then stops and reverse and takes "open[0] < close[1]"


I want each order entry, long-short to check for a position first, if flat trade, if not in a position wait until flat.


I've been looking through the support guide and can't seem to be able to find the correct code to compile this logic.


Thanks in advance for your reply.

[NinjaTrader_ChelseaB]

Hello TradingLoss,

You would need to use custom logic.

You could set a bool to true when the entry is placed, that must be false in the condition to allow a new entry to be submitted.
Then set to this back to false when the exit fills and the position is flat.

[TradingLoss]

Hello TradingLoss,

You would need to use custom logic.

You could set a bool to true when the entry is placed, that must be false in the condition to allow a new entry to be submitted.
Then set to this back to false when the exit fills and the position is flat.

Ok I'll give it a shot.