Strategy Analyzer changing BarsType

[RaddiFX]

Every time I compile an indicator or strategy, and ~1/3 times I run a strategy, all analyzer tabs will have the same buggy reaction where they change their barstypes to Minute.

I'm on 8.1.4.2 64-bit

[NinjaTrader_Jesse]

Hello RaddiFX,

Do you see this happen with the SampleMACrossOver selected? if so what specific steps do you use to see this happen?

[RaddiFX]

Tested with SampleMACrossOver set to seconds. As soon as I compiled(with no changes), it changed to Minute.

[NinjaTrader_Jesse]

Hello RaddiFX,

I don't see that on my end, what are the exact steps you are using? Please detail everything from what windows you open, where you apply the strategy, what steps you use in the editor and analyzer.

[RaddiFX]

When I open NT, I have open 4 windows in the workspace. Editor, Analyzer, Chart, and Control.

I'll change the barstype to anything other than Minute in the Type section in the Analyzer.

I'll compile in the editor.

After the Compile the type goes blank, then returns as Minute.

[NinjaTrader_Jesse]

Hello RaddiFX,

Unfortuatenly that does not help to see the problem, I still do not see that happening on my end.

The test that I had done was the following:

Open the analyzer
Open the NS editor
In the analyzer select a different timeframe with the SampleMACrossOver selected.
Run a test
In the editor press F5 to compile
The analyzer is unchanged.

I also tried not running a test so it was just these steps:
Open the analyzer
Open the NS editor
In the analyzer select a different timeframe with the SampleMACrossOver selected.
In the editor press F5 to compile
The analyzer is unchanged.

You may need to uninstall/reinstall
This could also relate to something third party you have imported
If your script is having an error that could also contribute, please make sure you are testing specifically the SampleMACrossOver strategy.