8.1.4.1 update not saving time frame on strategy analyzer

[NinjaTrader_ChelseaB]

Hello zagier,

Unfortunately, there has not been a new release of NinjaTrader at this time and the current version is 8.1.4.1 so there are not any new updates on this.

[ClauTrade]

Hello,

what about this bug? In last version 8.1.4.2 64-bit it is still resetting to 1 minute depending from compilation script too.

It seems keep setting but after a script compilation reset to 1 minute and sometimes it seems to keep set but at the end of RUN back to reset to 1 minute.

Saving setting to template (own or default) something change but finally always (with compilation or at the end of run) back to reset to 1 minute.

Thanks

[NinjaTrader_ChelseaB]

Hello ClauTrade,

Please watch the video in post # 3.

With the exact steps in the video is the behavior different.

[ClauTrade]

Hello Chelsea,

yes, I tested all combinations ... your video is a partial fix of the problem .. in your video you never RUN the strategy after default saving.

As I wrote at last of my post ...with default set save it keep set with compilation but reset to 1 minute at the end of RUN!

Check please if you get same issue .. thanks!

[NinjaTrader_ChelseaB]

Hello ClauTrade,

As mentioned in post # 11, the issue with the data series parameters reverting to default after clicking run has been previously reported and is marked for correction in a future release of NinjaTrader.

To confirm, you are not experiencing the issue of this topic with the data series parameters not saving with a workspace or in a duplicate window?

[ClauTrade]

Hello Chelsea, I lost just this detail in post #11 ... I got it!

Yes, without saving the reset to 1 minute is after compiling. Saving a template the reset is after Run.

I think it was a new bug from 8.1.4.1 but nothing has changed in 8.1.4.2 ... do you know if 8.1.4.0 works fine about this?

Please I hope you can fix soon, you know, it is just bit hard to develop and test, re-setting every time the data series!

Thanks. Regards

[NinjaTrader_ChelseaB]

Hello ClauTrade,

If you are compiling and the value is being reset, this is not the issue of this thread. That issue has already been reported.

We are testing typing a value, saving a template or workspace (without compiling), and then reopening the workspace or reloading the template.

With the exact steps shown in the video, and no other extra steps, are you experiencing different behavior than what is shown in the video?