multi targets not working for OCO order?

[flybuzz]

Hi I was experimenting with OCO order, I have surrounded the price with 2 separate orders, 1 buy stop and 1 buy limit order.
Each order has 2 contracts and it has ATM strategy attached to each one.







As you can see the ATM has 2 targets. But for whatever reason, after the order executes, it would group 2 contracts in Target 1, and not showing target 2 at all. If I only use standard buy or sell order, the different targets would show up properly for the 2 contracts. Is that a bug or how come it's not showing different targets if I try OCO order?

[NinjaTrader_BrandonH]

Hello flybuzz,

Thanks for your post.

We have received your inquiry and are researching this behavior at this time.

We will update this forum thread with more information after we have finished investigating this matter.

Thanks for your patience; We look forward to assisting further.

[NinjaTrader_BrandonH]

Hello flybuzz,

Thanks for your patience.

I have tested the scenario you reported on my end and when the buy stop limit or buy limit order is filled I'm seeing two profit target orders being placed at different values and one stop loss with a quantity of 2.

See this demonstration video showing the above behavior: https://brandonh-ninjatrader.tinytak...NV8yMTUyMzY3Mg

If you follow the steps seen in the demonstration video, do you see a different behavior?

Please let me know if I may assist further.

[flybuzz]

I appreciate you took the time to look at it. I noticed you selected the ATM strategy again the second time for the second leg. If I do that, then it works. I just don't understand why can't NT be smart enough to figure it out or automate that part so I don't have to select the same ATM strategy again. It's like waste of time. In trading, I often need to spend energy watching the price movement, when I do want to enter, I often only get few seconds to do that. Extra step like this, really doesn't help.