days to load feature in the data box question

[joecffv]

After right clicking the chart it pulls up a date series box, iin the box one item says Days to load. it set at 5 i change it to 100 click apply and ok. but it never stays at 100 and if i chanfe to a different time frame it does not carry over to that time frame.
is there a way to keep the days to load at 100 or some other higher number?????

thank you

[NinjaTrader_Zachary]

Hello joecffv,

Thank you for your inquiry.

When changing between different time frames, this value will switch back to the default value for that period type. You will need to change this default for each of the various period types in order for the setting to remain in place when switching from one type to another. You may view information about saving a Period Type preset at the link below;

https://ninjatrader.com/support/helpGuides/nt8/index.html?saving_chart_defaults_and_templates.htm#UnderstandingDataSeriesDefaultSettings

You would need to repeat the process for each period type that you use. For example, if you change the Days to Load to 100 for a minute chart and hit 'preset minute > save', this will only apply to minute intervals. If you switch to a Renko chart, the Days to Load will go back to the original default value for that period type until you repeat the preset process for that specific period type.

Please let us know if we may assist you any further.

[joecffv]

oh yes that worked i was not even paying attention to the little words preset under the box thank you