Alarms still working when close and re-open NT8

[tff2011]

Hi,

I would like to know if it`s possible to keep ALARMs plotted still working when I close the Ninja Trader 8 and then I open the software? I need that my alarms previously configured keep working normally...

Thank you

[NinjaTrader_ChristopherJ]

Hello,

Currently alert configuration is all held locally on your PC as opposed to on our servers therefore for alerts to trigger NinjaTrader would need to be open and connected.

I have submitted this suggestion to our development team and will follow up as soon as a tracking number has been assigned.

[tff2011]

Hello,

Currently alert configuration is all held locally on your PC as opposed to on our servers therefore for alerts to trigger NinjaTrader would need to be open and connected.

I have submitted this suggestion to our development team and will follow up as soon as a tracking number has been assigned.

Alright, but is it possible to keep alarms actived when I close and open the program?

[NinjaTrader_ChristopherJ]

If your alert is enabled and you save your workspace when opening NinjaTrader again the alert will be enabled.

[tff2011]

The big problem is...

I set an alarm on a horizontal line for example.

and then I save workspace and close NT8.... and then I open NT8.

THe problem is that the alarm is not linked to the object anymore.

See the attach

[NinjaTrader_ChristopherJ]

I have tested this and cannot reproduce this behavior on my end.

So I can further assist can you please tell me what version of NinjaTrader you have installed which can be found in the Control Center under Help->About.

Also can you tell me if you are using the Playback connection when this occurs.

[tff2011]

I have tested this and cannot reproduce this behavior on my end.

So I can further assist can you please tell me what version of NinjaTrader you have installed which can be found in the Control Center under Help->About.

Also can you tell me if you are using the Playback connection when this occurs.

I am using last version of NT8 8.0.9.0.

My connection is FXCM Demo.

First, I set the alarm on a Horizontal Line and then I close the software.

After that, I open the NT8 and the alarm is not linked anymore.

[NinjaTrader_ChristopherJ]

So I may test using your workspace please go to Help->Email Support and be sure to include Attn: Chris Jameson in the Subject line, a link to this thread in the body and a check in the box for "Workspace files and UI settings".