Changing an Indicators Script

[KyriakosCyprus]

Greetings, I have added a spread indicator that takes two assets(inputs) and deducts one from the other in any amount I enter.

While I would prefer if it divides the inputs.

Example: 1 MNQ - 1 MES

Change example 1 MNQ / 1 MES

I am trying to figure out through the NinjaScript editor on how to change into dividing the inputs, without any luck.

I have attached it below. Would appreciate any ideas on how to.

[NinjaTrader_Jesse]

Hello KyriakosCyprus,

To do math between two series you would just use the series you wanted in the equation, for example

Closes[0][0] / Closes[1][0]

As a side note using AddDataSeries with variables and logic like you have will fail to work in some tools, please keep that in mind as the results you view may be inaccurate. It is only suggested to hard code the secondary instrument, this is noted in the help guide:

https://ninjatrader.com/support/helpGuides/nt8/adddataseries.htm?zoom_highlightsub=adddata

Arguments supplied to AddDataSeries() should be hardcoded and NOT dependent on run-time variables which cannot be reliably obtained during State.Configure (e.g., Instrument, Bars, or user input). Attempting to add a data series dynamically is NOT guaranteed and therefore should be avoided.

[KyriakosCyprus]

Thank you but where should I insert the msg, as i understand this is the line that does the math. Screenshot below.