My Code NT8 works only for one bar then stops

[xamer]

Hi everyone,

My indicator lasts only for the length of one bar then it disappears
it only get back to work (for another bar) if i press F5

please advice

[NinjaTrader_Jim]

Hello xamer,

Thanks for opening the thread.

Is this an issue that is also observable in a system indicator? If so, could you provide more detail on how I can observe this as well?

If the issue is only with your code, that indicator will have to be debugged to understand the issue at hand. Without the full code I’m unable to test on my end. Additionally, debugging customer code escapes the scope of services we may provide.

First, I would check to see if there are any errors in the log tab of the Control Center.

Next, I would recommend to debug your script with Prints to observe any values that your variables are passing that would break the logic.

I would further suggest to comment out sections of the code to simplify the running logic until the code works, and then to uncomment sections until a problematic section of code is identified.

We have some further tips on debugging found here:

http://ninjatrader.com/support/forum/showthread.php?t=3418

As well as additional tips for writing NinjaScript code here:

http://ninjatrader.com/support/forum/forumdisplay.php?f=31

If you have any additional questions on any errors received or about NinjaScript code in general, please don't hesitate to ask.