How to create custom strategy on Keltner Channel

[davidd]

I'm new to this. I am not able to figure out how to use the wizard to create a strategy that will check Keltner Channel when the bars hit or cross over the top, then eventually hits or crosses over the bottom, and then eventually returns back to hit the middle, and when RSI comes back to 51, then place a sell order.

I will like to setup the opposite for a buy order. Any direction anyone can provide would be greatly appreciated. Thanks!

[NinjaTrader_Ray]

Take it one step at a time.
Take the first condition, crossing over the top and see if you can get that to work.
Try the CrossAbove() in the middle of hte condition builder where "close" is selected on the left and the upper Keltner channel on the right.

[davidd]

I'm able to setup each condition (when bar cross above upper Keltner Channel or below lower channel) but I'm not sure how to setup up the condition to handle the entire sequence. In other words, I want to check for the sequence when the bar touches/crosses the upper channel, then comes down and touches/crosses the lower channel, and then comes back up to touch the middle channel. How do you setup the condition to look at the entire sequence?

[NinjaTrader_Ray]

You have to break this entire set into each condition and create each of these conditions.

something like

if value two bars ago did this
if value one bar ago did this
if value on current bar does this

---> Take action