please help me a program

[trungruoi]

Shisha began as just another word for water pipe. Outside of the Middle East, people often call the pipe a hookah, and shorten "shisha tobacco" to "shisha". You do not need to know the history of the word to enjoy it, but you do need to know the information in this article.
>> Có thể bạn quan tâm: shisha là gì
Learn how a hookah works. This will help you follow the process. The bolded words describe the main part of the hookah.
The top of the hookah will hold the shisha tobacco, with hot coals above it.
Air sucked through the hookah to heat the coals, light the tobacco, and bring the smoke down through the main shaft.
The smoke leaves the stem at the end of the shaft, and enters the glass base of the hookah.
The smoke travels through water and air in the base, becoming cooler and more dilute.
The smoke moves through the hose and into your lungs.
Clean the hookah. Cleaning before the first use and after each smoking session will keep off the flavors out of your smoke. Wash all components with soapy water, except for the hoses. The hoses will rust or rot if they become wet. [1]
Clean glass components with warm or cold water. Hot water can crack glass.
Pour water into the base. Take a look at the glass base and make a note of where the ends are. Now detach the shaft and pour the cold water directly into the base. When reassembled, the tip of the stem should be about 1 inch (2.5 cm) below the surface of the water.
>> Có thể bạn quan tâm: shisha dien tu chinh hang
Too much water can get pulled into your hoses and ruin them. Always leave a layer of air at the top of the hookah.
Assemble the hookah. Fit the shaft onto the base, the hoses into the holes on the side of the shaft. Every connection should have a rubber or silicone "grommet" to make the fit snug and airtight. Test the connection between the bowl and the top of the shaft as well, then xóa the bowl for now.
Attach all the hoses even if you will only use one of them. Bảo đảm bảo mật của máy.
est the airflow. Place your hand over the top of the shaft, blocking the entire hole. Try to inhale through one of the hoses. If you get anything more than a trickle, there's a leak somewhere in your hookah. Check all the connections again and adjust as follows:
If a grommet would not fit snugly, wet it and try again.
Nếu kết nối giữa phần đầu và không phải là airtight, bao gồm shaft với masking tape where nó fits onto shaft. Thêm trang trong khi nó fits snugly, nhưng còn còn xoá to.
If another connection will not fit, wrap it in aluminum foil or moist paper towels. Nếu sử dụng giấy giấy hoài hoses, hãy nhớ rỗng them right after tuxedo.
Nguồn: cách sử dụng shisha điện tử

[NinjaTrader_ChrisL]

Hello trungruoi,

Thanks for the note.

Long limit orders can only be placed below the market price. Buy stop limit orders can be placed above the market.

The Range indicator is available to use in NinjaScript. It will give you the range of each bar for the series. You can also use the CurrentDayOHL indicator to get daily Open, High, and Low data even if your primary data series is not a daily series. The daily range can be calculated from that indicator like in this example:

protected override void OnBarUpdate()
		{
			if(State == State.Historical) return;
			if(Close[0] < CurrentDayOHL().CurrentHigh[0])
			{
				EnterLongStopLimit(CurrentDayOHL().CurrentHigh[0] + ((CurrentDayOHL().CurrentHigh[0] - CurrentDayOHL().CurrentLow[0])* TickSize), CurrentDayOHL().CurrentHigh[0]);
			}
		}

https://ninjatrader.com/support/helpGuides/nt8/en-us/?range.htm

Please let me know if I may be of any further assistance.