How to create optimization plot?

[Cyberjoe]

I'm still a NT newbie, and can't figure out how to create an optimization plot, similar to this image https://1drv.ms/u/s!Al47hEfk4PCSiOtnbG01wo10njui_Q

I run a two-parameter optimization in Strategy Analyzer, and would like to visually inspect the results.

[NinjaTrader_Jesse]

Hello,

To access the 3D graph, you could do similar to the following steps:

Click New -> Strategy Analyzer
Select Optimization
Select the SampleMACrossOver
Specify a range for both the Fast and Slow
Click Optimize.

Now in the results panel there is a dropdown menu in the top left. Click the drop down and go to "Optimization Graph".

A 2D graph should display, you will also see two drop down boxes at the top. Select Fast and Slow.

You should now see a 3D graph if there was enough data to plot. if there is not enough data or not enough parameters were optimized, you will get a messages saying there is not enough data.

I look forward to being of further assistance.

[Cyberjoe]

Thanks! I assume this is a new feature in NT8, as I couldn't find that magic dropdown in NT7 :-)