Restore Chart Defaults

[ivb73077]

Is there a simple way to programatically restore chart defaults? Or must it be done item-by-item for each of the properties that were changed?

Thank you.

[NinjaTrader_PatrickH]

Hello ivb73077,

Thank you for your post.

There is not a way to do this through NinjaScript in a supported manner. I am only aware of doing this manually and then select Set Default.

[ivb73077]

Thank you for the quick reply.

I know how to manually adjust the Bar Width and Bar Spacing, as well as how to control these via my code. I do not, however, know the default values of these two parameters. Is there a way to obtain the default values so that I may reset the chart defaults?

[NinjaTrader_PatrickH]

Hello ivb73077,

I am not aware of a means to grab the default value. If it has been changed it will be the value that is produced.