Patsystems and Kinetik EOD

[PeterPan]

ok here it is with data box

hope there is a solution

thank you very much

[NinjaTrader_Matthew]

Hello,

These settings should be working. It might be related to Eurex being closed - do you see the same behavior on any CME products?

If you cannot get these working, I would like to setup a phone call to look into this further. Please send an email to support[at]ninjatrader[dot]com with ATTN: Matthew in the subject and a phone number where you can be reached.

[PeterPan]

ok thank you for your reply

its everywhere the same

greetings

will send you an email