WFO Settings Problems

[brooksrimes]

In the WFO, you set "Parameters" in the top section.

I change those parameters to what I want them to be.

Then, between tests, NT7 resets them, forcing me to re-enter them.

This may be because I'm going to the Control Panel or Strategy Editor in-between test runs.

But I'm NOT closing the WFO window, so I don't know why it would reset the settings.

Is there anything I can do about this?

Brooks

[NinjaTrader_RyanM1]

Hello Brooksrimes,

I was only able to see this after compiling in-between tests. Is this what you're seeing or can you provide other steps?

You can save the settings used by Right Clicking > Save As default. This will keep those settings even after compiling.