Continuous ES contract and Pit session

[Baruch]

Hi,
I'm new to NT. I still use eSignal but want to migrate to NT.
I have ZEN-Fire data feed (simulation) and I try to show continuous ES contract but get no data.
Is it beciuse ZEN-Fire doesn't deliver? Do I have any options?
Another question: Is it posible in NT to show only Pit session like in eSignal "ES #F=2". It's not like setting start - end time because of day time savings and partial holidays.

Regards,
Baruch

[NinjaTrader_Jason]

Hello Baruch,

Unfortunately continuous contracts are not supported with Zen-Fire. You can merge individual contracts using the instructions at the link below.

http://www.ninjatrader-support.com/HelpGuideV6/Merge.html

Unfortunately this is not supported in the software itself. However, it seems to be supported by the data feed itself (eSignal) upon using that symbol mapping.

[Baruch]

Thanks Jason,
I tried the merge yesterday and it opens a "Loading data" window, but after few hours it was still in loadind mode. So I pressed the "Abort" button and for few hours more it was in abort mode. Then I crashed the NT and aseked how else it could be done.

Regards,
Baruch

p.s.
I entered the merge once again. Still waiting.

[NinjaTrader_Jason]

Hello Baruch,

I suggest to try the following if the current attempts fails. Create a chart for the historical data you like to merge. Check if all requested data is displayed to ensure you have access to all data. Create a chart for the instrument you will be merging the data to as well.

Try the merge once more.

If the issue persists, please post a screenshot of the Merge settings you use.

In addition, please ensure your PC meets the minimum requirements listed at the link below.

http://www.ninjatrader.com/webnew/support_installationguide.htm