Corruption problem ?

[T2020]

Can't get Tick or Volume charts to work right . Main thing is the time at the
bottom of the chart . On a chart setup from 4:00 am to 1:15 PST , the time
at the bottom of the chart says 12: 15 pm to 1:15 pm , but it looks like there's more data there then that . Also , all previously saved ATM's are missing . This seems to have all started after I signed up with Barcharts and
connected with them for the first time .

Minute charts seem OK .

[NinjaTrader_Jason]

ATM templates are saved in the NinjaTrader database located at My Documents-->NinjaTrader 6.5-->db-->NinjaTrader.mdb.

Could it be you renamed or deleted the database?

What instrument is selected in the chart?

Most likely, the first bar contains volume or tick data for the 4:00 AM - 12:15 PM time span.

[T2020]

ATM templates are saved in the NinjaTrader database located at My Documents-->NinjaTrader 6.5-->db-->NinjaTrader.mdb.

Could it be you renamed or deleted the database?

What instrument is selected in the chart?

Most likely, the first bar contains volume or tick data for the 4:00 AM - 12:15 PM time span.

Instrument : ES 03-09 -
There 2 mdb files there -NinjaTrader.mdb. and NinjaTrader.old.mdb ,
but I never created any additional files ?
Tick charts have the same problem "Time wise" as the volume charts ?
The time starts OK for today ,but all previous days start at 12:15 .

[NinjaTrader_Jason]

The NinjaTrader.old.mdb file indicates your database has been renamed. NinjaTrader uses the file named 'NinjaTrader.mdb' as database in the db folder. The old database contains your ATM templates. However, I do not suggest to rename NinjaTrader.old.mdb back to NinjaTrader.mdb and name the new database different. I am not sure why the database has been renamed, but it should have been renamed for a good reason.

Please use a lower value for the tick and volume interval. I tested an ES 03-09 150 tick chart with session begin and end times set to 12:00 AM and 12:00 AM and displayed data as expected.

[T2020]

Is there some code that allows Ninja to rename the file itself ? I'm sure I didn't. Would Repair Db do that ?

[NinjaTrader_Jason]

As far as I know there is no such code. Could it be the database was renamed during a remote assistance session with one of my colleagues?

Repair DB will not rename the database.

[T2020]

As far as I know there is no such code. Could it be the database was renamed during a remote assistance session with one of my colleagues?

That's a possibility . I let a guy from AMP do some remote assistance . I don't
like doing that and problems like this is the reason .