Keltner upper and lower bands

[Riverend]

New guy here. I 'm trying to set up a condition where I buy when say
a SMA crosses above the lower Keltner channel. I got started in the
"New Stratagey" menu but the keltner indicater look like it only has
the center line available to use as a crossing point.
if (CrossBelow(TSF(7, 7), KeltnerChannel(1.5, 10).Midline, 1))


Is there a way to use the upper and lower bands?
Thanks,
Vic

[NinjaTrader_RJ]

New guy here. I 'm trying to set up a condition where I buy when say
a SMA crosses above the lower Keltner channel. I got started in the
"New Stratagey" menu but the keltner indicater look like it only has
the center line available to use as a crossing point.
if (CrossBelow(TSF(7, 7), KeltnerChannel(1.5, 10).Midline, 1))


Is there a way to use the upper and lower bands?
Thanks,
Vic

Hello Vic,

Thank you for your post.

Click on where it says midline in the strategy builder and a menu will appear that will allow you to choose upper or lower bands.

[Riverend]

Thank you for your quick response. your link has the Sept. dates shown below. Will there be any Strategy Development classes befor the end of
the year?



What: Online Software Training Seminar
When: Course September 13th and 14th
Time: (10 AM EST until 3:00 PM EST each day)

[NinjaTrader_Ben]

Hello,

The next development webinar will be held on 11/11. This link has the entire schedule:

http://www.ninjatrader-support2.com/vb/showthread.php?t=11427