Adding parameters at a later stage...

[Sidhartha]

Hi All,

Having set up an indicator under the wizard and programmed the calculation code, I'm wondering whether it is possible to add more 'parameters' at this stage...?

i.e. under the Wizard I defined 2 inputs... However, I would actually like to have 3 inputs that I can optimize over at a later stage... Is it possible at this point to add a 3rd... If so, how...??

Many Thanks

[NinjaTrader_Dierk]

Please inspect the generated code and manually add code lines following directions of the generated code.

[Sidhartha]

When you say inspect generated code Dierk, do you mean within the section entitled "NinjaScript generated code. Neither change nor remove."...?

Many Thanks

[NinjaTrader_Dierk]

No you NEVER should touch that code region.

[Sidhartha]

Sorry... I assume (upon looking further) that you mean within the "Properties" region...?

[NinjaTrader_Dierk]

Right any code region which hold code referring to the generated properties apart from those which are marked as "don't touch".

[Sidhartha]

Separate question Dierk (or anyone else at NT)...

I have an indicator whose value is either 1, -1 or zero... Currently the chart autoscales such that when no values of either 1 or -1 are displayed it only shows the relevant portion of the line above or below zero.

Is there a way of forcing it to chart from -1 to +1 regardless of the output so far of the indicator value....??

Many Thanks

[NinjaTrader_Dierk]

>> Is there a way of forcing it to chart from -1 to +1 regardless of the output so far of the indicator value....??
Not that I'm aware of.