How can I plot using Plots[index]

[achalk]

I want to plot without refering to the DataSeries names (e.g. Plot0.Set(), etc.). So I would like to plot referring to the Plots[index] vales so that I can stick the command in a function that can refer to plots solely by there indwex in the Plots[] array.

Can I do this? All the examples that I have seen rely on the DataSeries name given in the Add() function.

Thks!

[NinjaTrader_Lance]

The Add() isn't naming the DataSeries. What your'e seeing is the DataSeries Values[x] is being assigned a name in the bottom #region properties

http://www.ninjatrader.com/support/helpGuides/nt7/index.html?values.htm

That being said, using Set() is the only supported way for handling these values. While there are other ways to assign a value we cannot support them as there are back-end calculations performed by using .Set()
If you didn't use this you could run into unexpected results.

[achalk]

Thanks. The Values[] array lin was what I needed.

- A