Could you change the editor, not to minimize regions when compile?

[leontancfa]

Hi, a suggestion.

I think it is common that you change a little part of the codes, compile and go check the chart if it looks right, and go back to that part of codes to make change again.

But whenever I click compile in editor, it minimize all the regions, and I had to open the region I want and then do the edit. A lot of time was wasted in that clicking process.

So could you change the compile process, so that it does not change the region status?

Thank you!

[koganam]

Hi, a suggestion.

I think it is common that you change a little part of the codes, compile and go check the chart if it looks right, and go back to that part of codes to make change again.

But whenever I click compile in editor, it minimize all the regions, and I had to open the region I want and then do the edit. A lot of time was wasted in that clicking process.

So could you change the compile process, so that it does not change the region status?

Thank you!

Comment out the region markers. You can always reenable them when you are done editing and going for the final compilation.