Ninjascript coding example for Bloodhound

[intrader]

I am looking to code signals outputted by a custom indicator (such as dots, arrows, diamonds etc.) into Bloodhound. I understand that additional coding is needed to make the signals shown by the chart markers on the chart available to Bloodhound solvers. I was told that there are some example codes in Ninja trader Support Forum. Can someone from Ninja support team or any forum members direct me to posts that show these example codes? Thanks in advance.

[sledge]

I am looking to code signals outputted by a custom indicator (such as dots, arrows, diamonds etc.) into Bloodhound. I understand that additional coding is needed to make the signals shown by the chart markers on the chart available to Bloodhound solvers. I was told that there are some example codes in Ninja trader Support Forum. Can someone from Ninja support team or any forum members direct me to posts that show these example codes? Thanks in advance.

I haven't seen anything here.

Is there anything at BloodHound? They have many hours of tutorials.

Anything at Big Mike's?

[NinjaTrader_Bertrand]

I would also not be directly aware of anything here, however generally if you cannot directly access a plotted value / signal, then the concepts showing in this sample below would be very helpful -

http://www.ninjatrader.com/support/forum/showthread.php?t=4991

[intrader]

Thanks for the link and references.