definining two indicator values in strategy wizard

[Riverend]

Hello,
I have been trying to use the Strategy Wizard to not enter a position until the value
of the buy line and the sell line is greater than say 20 ticks

If tick value greater than 20 ticks enter long above green buy line or enter short below sell red sell line. I know this is a third party indicator I found it on Big Mikes Site.

[NinjaTrader_JC]

Hello Riverend,

While, I am not familiar with the Indicator as long as the two lines are plot values that you can access you should be able to select them inside the Indicator section of the Condition Builder and be able to start creating your condition. So you can compare the two plot values and use a Integer Variable to set the offset. See attached image as an example.