Ray Line angle changes

[chris_hkg]

Hi,
Whenever I draw Ray line (Doesn’t matter the time frame of chart –more noticeable on daily / weekly charts), If I move the line to the far left of the chart, too the start of the data, the Ray line angle changes. In some cases the line angle will doesn’t appear to change until you try to move the line a few times to the left of the chart.

Cheers
Chris

[chris_hkg]

Lines doing strange things

also noticed when switching tabs of different charts (ie between daily / weekly FDAX charts). Ray lines go off at a point of the line then after a few seconds comes back to the normal ray line extension, see image

also on the odd occasion, depending on what type of snap mode used, after drawing the ray line, the line will only move to the left

[-=Edge=-]

also noticed when switching tabs of different charts (ie between daily / weekly FDAX charts). Ray lines go off at a point of the line then after a few seconds comes back to the normal ray line extension, see image

I can confirm I see the same thing when switching between tabs and/or rearranging them.. Rays jump to pointing up to left hand corner, and when connected to data, it seems that on the next tick, they then correct themselves.. What seems a little odd is if your not connected to data, they still jump, but seem to correct themselves immediately..

[-=Edge=-]

What seems a little odd is if your not connected to data, they still jump, but seem to correct themselves immediately..

After just a bit more testing.. It does look like when your not connected to data, they do seem to immediately correct themselves when switching between tabs.. But they do NOT when re-arranging the tabs. When re-arranging the tabs they will correct themselves on any render change though (scrolling/moving chart).. Just thought I'd mention this for additional clarification..

[NinjaTrader_AlexC]

Hi, thanks for your reports.

This has been reported previously. The internal issue tracking tag is NTEIGHT-8505.