Bugs in b22

[Baruch]

Hi,
1. In multi time frame strategy when I go to chart tab I'm unable to add indicators. Receive an error message "You cannot add/change/remove an indicator until your request has completed loading historical data".
If I change the main TF to my second TF run it and then change it back, I'm able to open indicators.
2. I installed clean install. NT imported my 6.5 workspaces, but I couldn't open them.

Baruch

[NinjaTrader_Jason]

Hello Baruch,

1. Are you able to reproduce the error message? Could it be data was still being loading as per the error message? Please try again once all historical data has finished loading.

2. Do you see the workspace name reflected in the upper left corner of the Control Center if you open the workspace? Could it be the workspace only contained charts? Please note that charts are not migrated between versions as per the link below.

http://www.ninjatrader.com/support/forum/showthread.php?t=21019

What will NOT be migrated

• Charts in workspaces

[Baruch]

Hi Jason,
Bug #2 you are correct, I had only charts. OK.
Bug #1 it happen always, even if I wait 10 hours (and I don't), but chart on a chart tab is shown only after the backtest finishes so its a bug!

Baruch

[NinjaTrader_Jason]

Hello Baruch,

Can you please send me your multi time frame strategy and include what exact steps you perform when the issue occurs. Please send it to support[at]ninjatrader[dot]com. Put 'Attn Jason' in the subject header and reference this forum thread.

When I test it using the SampleMultiTimeFrame strategy I can add indicators without experiencing the error message.