Beta 22nd "Snap Mode" issue

[frenchfry]

NT7 seems to be preset to "Snap Mode: Bar". Draw a line, then copy and paste it everything seems to work fine.

Do the same and change "Snap Mode: Disabled" or "Bar and Price". After you paste your copied line you either get a horizontal line or if you have for example volume displayed below price that pane is no longer visible.

[NinjaTrader_Bertrand]

Welcome to our forums frenchfry and thanks for reporting your issue in - we'll look into reproducing and get back to you.

[NinjaTrader_Bertrand]

frenchfry, was not able to reproduce here, copying and pasting in worked well on all snap modes for me - do you see this only for example when working on the added volume indicator directly?

[frenchfry]

Just did it again:

1. Open a new chart (no indicators). In this case FDAX 5 min. set it to OHLC and disable "Plot executions"
2. Snap mode is default to "Bar". Draw a line, copy, paste. You get a parallel line. Fine.
3. Change snap mode to "Disabled". Draw a line, copy, paste. Your pasted line in this example is nearly horizontal instead down and is by a multiple longer than your original line.

Some areas where I think our configurations could differ:

I use VMWare Fusion and have these indicators installed (but not loaded with the chart when I do the test):

http://www.elitetrader.com/vb/attach...postid=2902740 and http://www.elitetrader.com/vb/attach...postid=2983398

[NinjaTrader_JoshP]

Unfortunately I could not reproduce. Do you have any default chart templates set? Are you using non-equidistant charts? Maybe you are using a logarithmic y-axis scaling?