.Arrow points can occasionally reverse direction..

[Alfred]

Something minor....Arrow points can occasionally reverse direction when adjusting the draw tool arrow and sometimes when moving a finished arrow...screen shot below...have noticed on & off for some time...

Thanks....

[NinjaTrader_Brett]

Hello,

Thanks for your forum post.

I have tested this on my end however was not able to reproduce.

Is this something you can get to occur with a specific set of steps so that I can get to development or does this only occur randomly?

I look forward to assisting you further.

[Alfred]

Brett...I cannot reproduce right now either....seems totally random and happens not that often.

As it is now just the very tip point of the arrow seems anchored to the end of the line...and so it can swing around now and then the opposite direction....perhaps if the whole arrow head was anchored to the line direction so it could not swing around on the line ??...but this is super minor stuff and maybe is not worth the bother...

Thanks...

[NinjaTrader_Brett]

Hello,

Ok sounds good we will keep an eye on it and I will let development know.

If you find some steps that cause this to occur again please let me know

Thank You and have a good day.

[NinjaTrader_Christian]

Hi Alfred !

I could reproduce and fix the problem with the arrow head swining to opposite direction. FYI: this happened, when the slope of the line was exactly 1 (1:1 pixel), and the object or one anchor was moved.

Fix will be available with next update of NinjaTrader.

Kind regards,
Christian

[Alfred]

Hi Christian...!!...good to hear...!!

I kind of suspected you would be able to do a fix on that one ...

Thanks much...!!

[Alfred]

After Christian pointed out that a 45 degree slope on an arrow line can trigger the arrow pointer reversal, it was easy to set up several arrow lines to duplicate the behavior...


Again....thanks for the fix...!!