OnMarketData

[rt-trader]

Hi,

I have an indicator which uses OMD - it runs on several charts.

However, until any (all) of these charts are selected (brought into focus) the OMD indicator does not start.

This was an issue in early beta versions that was addressed and now appears to have returned.

Running b15

Thanks

[NinjaTrader_Bertrand]

Thanks for raising this rt-trader, we'll recheck the issue.

[NinjaTrader_Bertrand]

rt-trader, was not able to reproduce here on replay of ES 3 charts. Opening chart, apply sample indicator using prints from OMD, then minimize chart and remove focus by starting replay, no issues seen here - getting prints from OMD instantly after replay start. Could you perhaps attach the indicator you used in your testing?

[rt-trader]

Bertrand,

This issue occurs live, not with replay so try these steps;

1. Setup workspace with say 3-4 charts and apply your OMD indicator to each of them.

2. Before saving the workspace minimize all but 1 of the charts.

3. Close NT then restart using auto connect to a live feed.

4. The unminimized chart indicator should start processing.

5. After a couple of minutes running check one of the other charts - if the malfunction is present the chart will only start to process once selected instead of from the time NT started.

[NinjaTrader_Bertrand]

rt-trader, thanks for those very precise steps - was able to see the issue finally at play, thanks for reporting in.