NT 7 and FIn-Alg TPO Charts

[jackh]

I continue to have problems on NT7 Beta (Now14) when using TPO Charts. I can build charts fine but when I close and reopen either my computer locks up or the NT platform locks up. Workspaces not containing a TPO Chart reopen fine. The developer says no other problems reported to him. So is anyone else having problems? Please do not recommend fresh install etc. I have done all that several times. Also no problems with NT 6.5 on same computers.

[NinjaTrader_ChristopherJ]

Hello jackh,

Thank you for your post.

Yes, if the assemblies were not created with .NET Protector v3.1 you may experience issues.

Has the vendor that has provided you a compiled assembly to install? If that is the case please verify with the vendor the assemblies were created with .NET Protector v3.1 as that is required within NinjaTrader 7.

[Final]

TPOChart for NT7

TPOChart is not protected by .NET Protector so this is not relevant

[jackh]

Chris, yes I have the NT7 latest TPO Chart assemblies. Are you saying that the Remote Soft Software may only cause problems on reopening a chart?

I forwarded your reply to Fin-Alg the developer as he has avoided answering my direct question about this issue.

[Final]

TPOChart is not protected by .NET Protector so this is not relevant

[jackh]

Chris. Boy that was a fast response from FINAL about .net protector. So any other suggestions.

[NinjaTrader_ChristopherJ]

Please send a note to Support [AT] NinjaTrader [DOT] com with "ATTN: Chris" in the subject line.

In the message, please include the following:
1.) A link to this forum thread.
2.) Your most current trace and log files.

You will find the file here: My Documents > NinjaTrader 7 > Trace > trace.YYYYMMDD.txt

Log file will be located by going to Documents->NinjaTrader 7->Log->log.YYYYMMDD.txt

[ModularMix]

Hi, I reported the same issue recently.

See this thread: http://www.ninjatrader-support2.com/...ad.php?t=28028

I confirm jackh findings: i can build a TPOChart nicely. If I however shutdown and restart the session based on the workspace containing the TPOChart it can result in a freeze of this workspace.

[NinjaTrader_ChristopherJ]

Hi, I reported the same issue recently.

See this thread: http://www.ninjatrader-support2.com/...ad.php?t=28028

I confirm jackh findings: i can build a TPOChart nicely. If I however shutdown and restart the session based on the workspace containing the TPOChart it can result in a freeze of this workspace.

Thank you for reporting and confirming the issue as well.

[Final]

TPOChart for NT7

Hi

Please try this version (1.4.2) and let me know

http://www.fin-alg.net/downloads/TPOChart/TPOChart_NT7_Setup.exe

Final

[danieljsalas]

Is it working with the revised version of fin alg?

[ModularMix]

No unfortunatly not for me: the 1.4.2 version still leads to the freezing when restarting the session. I tried load the TPOChart template in a new WorkSpace but this also makes the workspace non-responsive, sometimes this procedure helps to get it active again.

[danieljsalas]

There is a new version for nt7 is it the one you are using?

[ModularMix]

Yes, I am using TPOChart for NinjaTrader 7, version 1.4.2.

[NinjaTrader_ChristopherJ]

Hello,

Please attempt the same procedures on the next release of NinjaTrader 7 and let me know if the issue persists.