Bad Data?

[raycam]

I have a daily chart and a long term tick chart. Both are set on the same session template. Here in Australia I check the charts before bed - just before the session in US opens. All was ok til I reloaded the charts this morning 4pm NY time. AS you can see the open on the daily is very different to the one on the tick chart. In fact it took till 1 pm to hit the open declared on the daily.
What is happening?
raycam
6E is the contract.
what is the correct template for that?

[NinjaTrader_Kyle]

Hello raycam,

Thank you for your post.

1.) Which data provider are you using?

2.) What were the specific interval values for these charts?

[raycam]

Zen Fire through Mirus Futures
daily on the top
and 2584TIck on the bottom

[NinjaTrader_Kyle]

Hi raycam,

Thank you for your reply.

Daily bars from Zen-Fire are downloaded from the NinjaTrader historical data servers. Those daily bars are stored based off of RTH session templates.

In this case, it would not matter which template you set - values in the daily chart will be different from values reported in the tick chart.

[raycam]

Should I reset all templates to RTH?
Would that set the tick to be the same as the daily?
raycam

[raycam]

Could you assist me please in the selection of the correct template from the drop down list for the EURO/US- 6E ?
There seems to be a number of RTH templates.
Thanks
raycam

[NinjaTrader_Kyle]

Hello raycam,

Thank you for your reply.

Regardless of which template is used, you will see differences between tick and daily charts such as these.

This is because the tick bar would not necessarily start at the exact same moment as the daily bar. For example, if a tick bar runs past midnight before a new bar is created, all values would be part of the last tick bar of the previous day.