Loading the future

[Curtis4S]

I am having problems with loading data. Historical data currupted message appears in the log, a lot. I am unable to reload data via the chart nor from the historical data manager. I have repaired and reset DB several times. close and reopen. Disconnect and reconnect, and when i open charts i can see in the control center bottom right, that it is trying to load 12/8 and its 12/7. I hit the flashing abort button and charts appear. However each time i do that the very next bar begins a new session. I seem to have complete data now, however this morning upon initial opening, there was a very long bar that covered a few hours of time, and indicators were skewed.

Thanks for your help

Curt

[NinjaTrader_JoshP]

Curt,

Please close NT, go to Documents\NinjaTrader 7\db. Delete all the contents inside that folder and restart NT.

What data provider are you using? What kind of charts are you opening? Thanks.

[Curtis4S]

Thanks Josh, that worked. I still see 12/8 when loading. And it is taking a lot, 10 times longer to load, but data looks good and sessions are accurate.
Zenfire is my provider and I use some basic EMA's, Lin reg lines, macd's and some Fib retracement indicators. Half are special scripts that have had a little early trouble working properly. Now only special Macd's are breaking code when scrolling back. The Macd dots repeat their pattern. So from a current plot back around 200 plots, it is accurate, then any further back and it's the same 200 as the most recent. The strange thing is when i adjust an indicator and hit "apply" or "OK", the Macds are ALL accurate for about 10 sec, then the code breaks and the funky pattern plots?
My workspace contains Minute, Tick and volume charts. A total of 7 charts.
Does this repetitive problem have "cousins". And is there a cure?
One last thing, is Zenfire working on supporting the 64bit system?

Thanks

Curt

[NinjaTrader_JoshP]

Curt,

I suggest you inquire with the original author for debugging the indicator in NT7. The repetitive issue you experience is likely a bug in the indicator.

As far as loading data, tick and volume charts will take awhile to load depending on how much data you are actually pulling.

Zen-Fire does not currently support 64-bit.