dom and indicator

[markw]

hello

1.The bar timer does not work with a 30 second chart.(says not a valid interval)
2. Work station will not close(says due to open work space)
3. Using scroll wheel on the dome to move prices is erractic sometimes it moves fine other times it will jump off the dome and sometimes it will change the market being traded(example if in trade on ES and scroll will change over to FDAX.Also on 6.5 I was able to left click above and below targets and stops to move them, now I have to click on the target or stop and then move it.

mark

[NinjaTrader_Ray]

hello

1.The bar timer does not work with a 30 second chart.(says not a valid interval)
2. Work station will not close(says due to open work space)
3. Using scroll wheel on the dome to move prices is erractic sometimes it moves fine other times it will jump off the dome and sometimes it will change the market being traded(example if in trade on ES and scroll will change over to FDAX.Also on 6.5 I was able to left click above and below targets and stops to move them, now I have to click on the target or stop and then move it.

mark

1. Will check into
2. Can you provide exact message or screen shot?
3. Make sure that the instrument combo box is not highlighted, you can move your mouse around the DOM to disable the highlight (this was also the case with 6.5). In the order modification, right click in the DOM > Properties and set the single click order modification property to true.

[markw]

hi Ray


screen shots attached




mark

[NinjaTrader_Ray]

Thanks.

Can you provide me the exact steps in how you shut down NT including the names of the buttons/options you select. Thx.

[markw]

hi Ray

1 Enter File and Disconnect and left click on Mirus.
2 Enter File and Workspaces then left click on Close Workspace and when I do the pop up Error sign comes up.(You can not close the last open workspace)


thanks

mark

[NinjaTrader_Ray]

hi Ray

1 Enter File and Disconnect and left click on Mirus.
2 Enter File and Workspaces then left click on Close Workspace and when I do the pop up Error sign comes up.(You can not close the last open workspace)


thanks

mark

Thanks Mark. This is expected since NT must have one workspace open at minimum. To close the application, just select File > Exit.