Candle Bar Signal Average and desviation conditions

[icebergdelphi]

There is some indicator where if the candle exceeds the average or standard deviation conditions, and its volume or delta is higher than the average, a vertical signal will be displayed on the chart.?

Something like this:

[NinjaTrader_ChelseaB]

Hello icebergdelphi,

Just to confirm, you are posting in the General Development section of the forums because you are developing this indicator yourself and you are wanting assistance with the code?

(Or were you intending to post in the NinjaScript File Sharing section of the forums to request an completed indicator you can download and import?)


Below I am providing a link to a support article with helpful resources on getting started with C# and NinjaScript development.

https://support.ninjatrader.com/s/article/Developer-Guide-Getting-Started-with-NinjaScript

"if the candle exceeds the average or standard deviation conditions"

You can check if the Low[0] of the bar is above the StdDev() indicator.

if (Low[0] > StdDev(14)[0])

https://ninjatrader.com/support/helpGuides/nt8/low.htm

https://ninjatrader.com/support/helpGuides/nt8/standard_deviation_stddev.htm

"and its volume or delta is higher than the average"

You can compare the Volume[0] to an SMA() of the Volume.

if (Volume[0] > SMA(Volume, 14)[0])

https://ninjatrader.com/support/helpGuides/nt8/iseries_volume.htm

https://ninjatrader.com/support/helpGuides/nt8/moving_average_-_simple_sma.htm

If you were trying to get values from the Order Flow Cumulative Delta, this indicator could be called.

https://ninjatrader.com/support/helpGuides/nt8/order_flow_cumulative_delta2.htm

"a vertical signal will be displayed on the chart.?"

You can draw a vertical line with Draw.VerticalLine().

https://ninjatrader.com/support/helpGuides/nt8/draw_verticalline.htm

Or you can color the chart behind the bars by setting the BackBrush.

https://ninjatrader.com/support/helpGuides/nt8/backbrush.htm

[icebergdelphi]

Wooo Thank you Chelsea , yeah my signal is going to be this: BackBrushAll = new SolidColorBrush(Colors.LimeGreen) {Opacity = 0.25}; BackBrushAll.Freeze(); Thank you for the clue I got it-