Bad Error

[NinjaTrader_ChristopherJ]

That seemed to fix the problem for now to load the data.
But no doubt it will do it again.
Can you please tell me why when I startup NT with a blank workspace.
And then connect to broker, it has to load all my workspaces at once?
I only have 3, one blank, one with a few test charts and main workspace with 5 charts.
Yet I don't want the 'This request cannot be aborted' boxes popping up every time I connect to the data feed.
I just want it to connect, do my stuff, and then if I load that workspace then it should load.
Do I have to physically remove the workspace file if I want to start it without it popping up the boxes?

To close workspaces that are not in use please go to File-->Workspaces and open workspaces are listed below 'Save Workspace As'. The workspace with the checkmark is the workspace opened on your monitor. Any additional workspaces listed, are opened in the background.

Select a workspace without a checkmark and subsequently go to File-->Workspaces-->Close Workspace. Repeat this process until only one workspace is opened.

I have provided a link below to our Help Guide that goes over Managing Workspaces.

http://www.ninjatrader-support.com/HelpGuideV6/ManagingWorkspaces.html

Please let me know if I may be of further assistance.

[eDanny]

You can close the workspace you aren't using. When you say 'yes' to saving all workspaces when you shut down, the closed workspace shouldn't open next time.

[Mike_32]

That seemed to fix the problem for now to load the data.
But no doubt it will do it again.
Can you please tell me why when I startup NT with a blank workspace.
And then connect to broker, it has to load all my workspaces at once?
I only have 3, one blank, one with a few test charts and main workspace with 5 charts.
Yet I don't want the 'This request cannot be aborted' boxes popping up every time I connect to the data feed.
I just want it to connect, do my stuff, and then if I load that workspace then it should load.
Do I have to physically remove the workspace file if I want to start it without it popping up the boxes?

[NinjaTrader_ChristopherJ]

Hello Mike 32,

Thank you for your post.

Please follow the instructions below to repair the NinjaTrader database.

• Disconnect NinjaTrader from any open connections via File > Disconnect
• From the NinjaTrader Control Center window select the menu Tools> Options
• Select the "Misc" tab
• Press the "Repair DB" button
• Press the "OK" button

Please let me know if I may be of further assistance.

[Mike_32]

Why do I get this Error?Why does it have to happen?
ERROR: outer try/catch in Add()
ERROR: Failed to call 'Add' method: Object reference not set to an instance of an object.